(Steel plates are relatively hard products, usually stacked in pairs of 200 sheets, so it is normal for the protective film to have some scratches, which does not affect the normal use of the template. Customers who mind should be cautious when taking photos.)

Nail enhancement transfer tool printing steel plate nail enhancement printing nail polish seal template diy printing set

Size: 12CM * 6CM

Weight: Approximately 21G

Nail printing machine operation method:

1. Remove the print head and clean the adhesive head with cotton dipped in nail polish remover

2. After simple nail repair and cleaning, apply a layer of base oil or gloss oil to enhance the coloring power of the nail surface. Wait until it is completely dry before painting.

3. Brush the selected pattern on the steel plate with the selected colored nail polish, and scrape the nail polish beyond the steel plate pattern with a scraper at a 45 degree angle.

4. While the nail polish is still wet, press the seal cover firmly onto the pattern (the key to this step is to quickly rotate the seal slightly during the operation, as both the seal and nail surfaces have curves, you can check if the pattern transfer is perfect), and transfer the pattern onto the seal head.

5. Transfer the pattern on the print head onto the surface of the nail, making sure to rotate it slightly.

6. You can add some embellishments to the pattern (such as shining powder or setting diamonds on flower cores, animal eyes, and other places you think need to be embellished), and apply gloss oil to protect the pattern from scratches or fading.

7. Use a cotton swab dipped in nail polish remover to clean the steel plate, scraper, and print head.

When printing patterns on the plastic surface of valuable accessories such as mobile phones, if there are problems such as wrong printing, wait until it is completely dry and gently scrape it off with a fingernail. Do not coat the surface with glossy oil or clean it with nail polish remover, otherwise it will corrode the plastic surface.